TI AM64X (in early development)

The TI AM64X was used with the TMDS64GPEVM development board.

Firmware

A start to building custom firmware images can be found in the TI documentation. Both a custom image and a default image provided where used during testing. When building a custom image, include the PREEMT-RT patch and the iproute2 package. OpenSSH should be included for convinience.

Building the CC-Link IE TSN Remote Station Application

The application can be built with aarch64-linux-gnu-gcc.

Navigate to the project folder of a sample application, e.g. “projects/goal_ccl_ie_tsn/04_remotestation/gcc”.

Select the target platform (only required once)
- make select
- enter the number of “linux_ti_am64xx”
build sample application
- make

The binary is located at
“projects/goal_ccl_ie_tsn/04_remotestation/gcc/linux_ti_am64xx/goal_ linux_ti_am64xx.bin”.

The file must be copied to the TMDS64GPEVM , e.g. via scp.

Debug Interface

A serial console is available on UART (J26).

Use the following parameters: 115,200 baud/s, 8 data bits, no parity, 1 stop bit.

Preparing the board

The board needs to be prepared to use send queues for communication. The following script sets up the queues and disables round robin sending.

#!/bin/bash

ifconfig eth0 down
ifconfig eth1 down

ethtool -L eth0 tx 8                                    # 8 send queues
ethtool --set-priv-flags eth0 p0-rx-ptype-rrobin off    # disable round robin

ifconfig eth0 up
ifconfig eth1 192.168.1.5 up

ethtool -l eth0
ethtool -l eth1

Note: Queue Setting and Round Robin deactivation affect all interfaces. All interfaces need to be down for this to work.

Execute the script:

./queue_setup

Running a Program

To run a program, simply copy it to the board, make it executable, and run it with:

chmod 777 ./goal_linux_ti_am64xx.bin
./goal_linux_ti_am64xx.bin -i eth0

Note: the -i parameter defines the used interface. In the current version this has to be eth0.