Figure 4 display the highlighted 9 pin connector J302 on bottom side of SoM_IoT_1V2 printed circuit board. With further development of Intelligent RJ45 Module, the SoM_iRJ45 supports additionally two CANopen ports. Both ports just offer the transceiver (TX) and receiver (RX) signals per port. For complete CAN connection, additional components are required. Following Figure 4 give an overview about the connection pins of J302. Subsequently all 9 pins will be described.
Pin 10 (P1ACT) offers ethernet port 1 activity indicator signal associated with R-IN32M3-EC Port RP04.
Pin 11 (P1LINK) offers ethernet port 1 link indicator signal and is connected with CATLINK1 signal for EtherCAT confirm indication requirements. This signals are associated with R-IN32M3-EC Port P05 and P07.
Pin 12 (P0ACT) offers ethernet port 0 activity indicator signal associated with R-IN32M3-EC Port RP02.
Pin 13 (P0LINK) offers ethernet port 0 link indicator signal and is connected with CATLINK0 signal for EtherCAT confirm indication requirements. This signals are associated with R-IN32M3-EC Port P04 and P06.
Pin 14 (VCC33) can be optional connected with external DC voltage source. The SoM_iRJ45 is specified for an input voltage range of 3,15V DC to 3,45V DC.
Note: Higher voltage (above 3.6V DC) at power supply pins may cause damage this module!
Pin 15 (GPIO0) is directly connected with R-IN32M3-EC. Port 5 Pin P53
Pin 16 (GPIO1) is directly connected with R-IN32M3-EC. Port 5 Pin P54
Pin 17 (GPIO2) is directly connected with R-IN32M3-EC. Port 5 Pin P55
Pin 18 (GPIO3) is directly connected with R-IN32M3-EC. Port 5 Pin P56