...
The UART-interface of the Renesas Synergy S7G2-SK is accessable through the J10 connector. Please set jumper J9 to 3-5 and 4-6 (RS485 mode). Then the UART TX line from the Synergy CPU will be connected to Pin 4 of J10. This is where the RX line from the USB-Serial converter needs to be connected. You can access the UART by launching a serial monitor like putty. Choose the following settings:
Speed | 115200 |
Data Bits | 8 |
Stop Bits | 1 |
Parity | None |
Flow Control | XON/XOFF |
Application
After setting up the serial monitor and starting the application, the output should look like this:
...