...
Connect both boards (see Figure above). Voltage supply is done through the VCC33_Sockel by the Rl78RL78/G14.
| Note |
|---|
Please connect both boards with each other, before you connect them per USB to your computer. |
EtherCAT Distributed Clocks
The Platform RL78/G14 supports the feature EtherCAT Distributed Clocks (DC). The synchronization signal SYNC0 from the SoM is connected through the Arduino Adaptershield to the RL78/G14. To use the signal SYNC1 a bridge is needed to connect the pins 7 and 4 of the Arduino Adaptershield. Connected as shown in the figure below, both of the SYNC signals cause an interrupt on the RL78/G14.
...
Using delivered build system
...
| Code Block |
|---|
make PLATFORM=rl78g14 clean |
| Info |
|---|
To run an application without connected debugger, the jumper EJ1 on the device must be closed. |
Using e2 studio by Renesas
...
Speed | 115200 |
Data Bits | 8 |
Stop Bits | 1 |
Parity | OddNone |
Flow Control | XON/XOFF |
Application
...